How can I change the rev-up and stop ramps programatically ?I can change the rev-up ramp through motor pilot but I have to do it everytime it connects.I want to control that through the program.I'm using code generated from the MC WB / MC MX / MX IDE...

When compiling a test app for the B-G431B-ESC1 board, I generated code using the MC Workbench and cube MX for a 6-step control of a BLDC.If while in the Workbench, I choose to enable the "Electronic Speed Control" option, I get the error below when c...

I ordered an STEVAL-ESC002V1 board (not yet received) and I'm unsure on how to upload the firmware.I believe it will be through ST-Link but will I need any special hardware for it, or a serial port will do ?