About bc

bc · 2020-09-20

I'm working with the STM32-base template for F4 located here:https://github.com/STM32-base/STM32-base-F4-templateTo compile with gcc toolchain and loading the binary with STLink Utility. The binaries work fine on the board, but I cannot figure out ho...

bc · 2015-11-30

Posted on November 30, 2015 at 17:09Hi all, I'm trying to get the BSP audio drivers working with the mbed Arm online compiler. ST has posted a numbed of the drivers for the new F7 discovery board https://developer.mbed.org/teams/ST/code/BSP_DISCO_F7...

bc · 2020-09-24

Aha! Yes, this gets it working for ITM_SendChar(). The system clock I set in STLink Utiliy for SWV was 168MHz. I'll write a more full reply tomorrow when I can more fully go through the points in your post, but it's great to have some character outpu...

bc · 2020-09-21

Thanks Clive. Where do I find the PLL clock source? Setting HSE_VALUE to 8MHz here and System Clock to 168MHz doesn't show anything on the SWO viewer in STLink Utility. The 'main.c' file is here:https://github.com/STM32-base/STM32-base-F4-template/bl...

bc · 2020-09-21

Thanks Nikita! I put this in main.c and called it as swoInit(0xFFFFFFFF, 168000000, 2000000); I also had to set bItmAvailable (=1) since it doesn't appear in the code anywhere. Are these arguments correct, and if not how do I determine what they shou...

bc · 2020-09-21

Thank you clive. In the STM32F407G-DISC1 manual (UM1472, page 27), the corresponding solder bridge seems to be SB12, is that right? This is soldered on the back of the board (there seems to be a small smd resistor across it, I did not solder this mys...

User statistics

User Activity

How to enable SWO with ST-Link Utility on STM32F407G-DISC1

DISCO_F746NG - using BSP_AUDIO on mbed

Re: How to enable SWO with ST-Link Utility on STM32F407G-DISC1

Re: How to enable SWO with ST-Link Utility on STM32F407G-DISC1

Re: How to enable SWO with ST-Link Utility on STM32F407G-DISC1

Re: How to enable SWO with ST-Link Utility on STM32F407G-DISC1