About AkhilDP

AkhilDP · 2024-11-15

Hello,We have a 5 pole pair magnet rotor and we have been using STEVAL-CTM009V1 development kit along with NUCLEO-G474RE development board.First, we did a preliminary testing with a sensorless control (observer+PLL) and after understanding the aspect...

AkhilDP · 2024-11-20

Hello @GMA ,Did a few trials and upon changing the Hall Sensor sequence and repeating the same exercise and below is the graph attached. This is reporting the same rotation direction.Also, agreed that Motor Profiler tool doesn't support ICS topology....

AkhilDP · 2024-11-19

Hello @GMA.We have verified phases U, V, W and Hall Sensors H1, H2, H3 are correctly connected. We did check hall Signal output while spinning it by hand and found them to be correct according to the requisites mentioned in this documentation (Launch...

AkhilDP · 2024-11-18

We followed the steps as mentioned in the documentation mentioned below suspecting an issue with the hall sensor displacement angle.(Launch Workbench 6.1.2 -> About -> Documentations -> User Manual -> Hall sensor feedback processing)Upon following th...

User statistics

User Activity

Unable to spin the motor using Speed Sensing Mode - Hall Sensor

Re: Unable to spin the motor using Speed Sensing Mode - Hall Sensor

Re: Unable to spin the motor using Speed Sensing Mode - Hall Sensor

Re: Unable to spin the motor using Speed Sensing Mode - Hall Sensor