About lwatcdr

lwatcdr · 2024-09-23

While in debug I get and error in this line of code. I do not get an error when running code not in debug./* Wait till HSE is ready */while (READ_BIT(RCC->CR, RCC_CR_HSERDY) == 0U){if ((HAL_GetTick() - tickstart) > HSE_TIMEOUT_VALUE){return HAL_TIMEO...

lwatcdr · 2024-09-23

I have two questionsSo why does it fail only in debug but when I run not in debug.Where do I set the HSE to 16Mhz.

lwatcdr · 2024-09-23

Yes it is.

lwatcdr · 2024-09-23

No that would take forever. I have used break points to find where the error is set. I increased the HSE time out to 10000 so it should be plenty of time.Start in debug. Hit continue. It runs and then hits a breakpoint on the return a time_out. No si...

lwatcdr · 2024-09-23

I left out on detail it works fine when I run it but fails when I am trying to debug it

User statistics

User Activity

READ_BIT(RCC->CR, RCC_CR_HSERDY) fails with a HAL_TIMEOUT when running blinky in debug.

Re: READ_BIT(RCC->CR, RCC_CR_HSERDY) fails with a HAL_TIMEOUT when running blinky in debug.

Re: READ_BIT(RCC->CR, RCC_CR_HSERDY) fails with a HAL_TIMEOUT when running blinky in debug.

Re: READ_BIT(RCC->CR, RCC_CR_HSERDY) fails with a HAL_TIMEOUT when running blinky in debug.

Re: READ_BIT(RCC->CR, RCC_CR_HSERDY) fails with a HAL_TIMEOUT when running blinky in debug.