About Huijie

Huijie · 2024-07-29

Dear community:I am currently using the STM32H563ZGT6 chip, and my code capacity exceeds 512KByte. When programming through CubeIDE, I can only burn to the 512KByte Flash of Bank1. May I ask if this chip can use Bank1 and Bank2 as a whole (as I have ...

Huijie · 2024-07-30

Dear TDK:Thank you very much for your suggestion. I tried to disable the 'verify after download' option, but the result is still the same. I am not sure if it is an issue with the STM32CubeProgrammer.In addition, I used STM32CubeIDE for simulation de...

Huijie · 2024-07-30

Dear TDK: You can see that my burned file exceeds 512KByte： I have checked the 'Verify after downloading' option: As shown below, the verification failed at position 0x08080000: 19:58:07 : ST-LINK SN : 12004500130000504141514E 19:58:07 : ST-LINK ...

Huijie · 2024-07-30

Dear TDK:The allocation of RAM and Flash in my link file is also the same as yours:Before raising this question, I searched the Internet for information about Dual Bank. Some STM32 series of chips can be configured with option bytes to choose whether...

Huijie · 2024-07-30

Dear TDK:The project I created using CubeIDE should not have any issues with link file exceptions, and I have also checked the. ld link file. The size of the Flash space allocation is also 1MByte.Best Regards!

User statistics

User Activity

STM32H563ZGT6: Use both Flash banks for 1MB code

Re: STM32H563ZGT6: Use both Flash banks for 1MB code

Re: STM32H563ZGT6

Re: STM32H563ZGT6

Re: STM32H563ZGT6