FAQs
VVW
Associate II
since ‎2024-07-08
‎2024-11-26

User statistics

  • 6 Posts
  • 0 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

what is the difference between the Sensors displacement and Placement electrical angle

2024-10-22
I am working on the 6 step motor algorithm development using MC workbenchin that under Motor tap-> there is hall effect on and off radio button is provided , when the radio button is set to On it is asking for the two new parameter 1. Sensors displac...

In the HV (J1) connector of the EVALSTDRIVE601 , how much power should be connected

2024-10-22
Hi ,  I am using the EVALSTDRIVE601 inverter board for the motor controlling application firmware developmentI need your input on power supply required for the EVALSTDRIVE601 board on the EVALSTDRIVE601 board, a J1 (HV) connector is provided to drive...

Getting start up failure on ST Motor Pilot

2024-07-17
Hi ,I am getting the "Start up " failure after motor runs for 1sec or immediately  after motor start rotating.Could you please provide me the details of the all fault meaning and your suggestions to resolve this "start fault?if you need any further d...

MC workbench showing the message Code generation completed with error

2024-07-15
Hi I have added the required details in the MC workbench and clicked on "Generate the project" After that, the below window pops up.  in that under Firmware Package Version it is providing the three option to select 1. STM32 FW V1.11.52.STM32 FW V1.1...

Need the required setup for the EVSPIN32F0602S1 motor controller board

2024-07-08
Hi, We have purchased EVSPIN32F0602S1 motor control board.  thus to make setup for the motor controller . I need the details on the required software and the procedure to setup and start motor control using the same board.if you have any developer gu...
Top