About Ryoma

Ryoma · 2024-10-09

Hello expert,We are designing a circuit using STWLC38.What happens if the capacitance value of C8~C11 in the figure below is increased to 47n?Will it be a problem?Regards,Ryoma

Ryoma · 2024-07-02

Hello,I'm currently considering using STWLC38.I have a question about connecting unused pins.How should unused pins be handled?(GPIO, SCL, SDA, INTB, VS, etc.) Regards,Ryoma

Ryoma · 2024-10-10

Hi Willzhou, Thank you for your help with another Thread. In the following thread you suggest increasing the capacitance values of COMPA and COMPB, why is that?STWLC38JRM does not output 5V at VOUT pin - STMicroelectronics Community I understand tha...

Ryoma · 2024-07-05

Hi willzhou,Thank you for your response.I now understand how to handle unused pins.:smiling_face_with_smiling_eyes:Regards,Ryoma

Ryoma · 2024-07-02

Hi willzhou,Thank you for your prompt response.I'll set SDA/SCL pin as test point as you suggested. Let me check again.May I also OPEN the VS pin?Currently, only Rx mode will be used.

User statistics

User Activity

Suitable capacitance values for COMPA and COMPB

Handling of unused pins of STWLC38

Re: Suitable capacitance values for COMPA and COMPB

Re: Handling of unused pins of STWLC38

Re: Handling of unused pins of STWLC38