About tomcat

tomcat · 2024-06-21

If the board power supply does not supply enough current (3A), the red LED indicates the issue following the rules below:LED blinking mode Console message Boot processTwiceWARNING 500mA power supply detectedCurrent too low, use a 3A power supply!Cont...

tomcat · 2024-06-26

I bought another power cord：The previous log is no longer printed：Previous ADC measurements was not the one expected, retry in 20ms********************************************************* WARNING 500mA power supply detected ** Current too ...

tomcat · 2024-06-23

First of all, thank you for your reply!I've tried using an USB Type-C charger, the result was the same.--"Alternatively, there is way to disable this check in the device tree. " --What can I do to disable this check in the device tree?

User statistics

User Activity

Cannot light up the LCD of STM32MPU135-DK

Re: Cannot light up the LCD of STM32MPU135-DK

Re: Cannot light up the LCD of STM32MPU135-DK