About JagadishB

JagadishB · 2024-05-02

Hi Everyone.As mentioned in the subject I have 2 Nucleo F767zit. where i configured one board as Host(CDC) and another as Device(CDC). I referred MOOC USB training(https://www.youtube.com/playlist?list=PLnMKNibPkDnFFRBVD206EfnnHhQZI4Hxa), configured ...

JagadishB · 2024-09-03

Hi. @B.Montanari I'm working on F767Zi-nucleo to implement USBX CDC ACM, I was following the steps as u mentioned here, but same options are not present for my board. like USBX Device System Stack Size is not available to alter and later steps are al...

JagadishB · 2024-07-18

Hi @amlok.1 .I'm also working on the AD7766, can please give input regarding this.thanks.

JagadishB · 2024-07-17

hey @sulochana.I'm also working on similar type of work can u please help with how to set up the communication between PC and micro-controller through Ethernet. As I'm beginner unable to figure-out the right way of configuring it. awaiting your respo...

JagadishB · 2024-06-03

hi @epsi1onyou can use normalization to shift the signal for better representation, before that use voltage divider circuit to reduce your range from (-10 to +10) to (3.3 to 0)

JagadishB · 2024-05-24

Hi @FBL .Thanks for the reply with details.Referring the image above I think that the enumeration process is working fine, after enumeration process when the communication begins, the host (being Nucleo F767) will send the data which is being receive...

User statistics

User Activity

I'm working with Nucleo F767zit Board, Where two same board need to communicate Through USB_otg_fs.

Re: How to implement the USB Device CDC (VCOM) in STM32 using the Azure USBX package

Re: I need to integrate the AD7766 library in STM32CubeIDE

Re: How to communicate two microcontrollers to a single pc via ethernet tcp/ip

Re: A usable and minimal USB osciloscope with bluepill

Re: I'm working with Nucleo F767zit Board, Where two same board need to communicate Through USB_otg_