About pagurudeen

pagurudeen · 2024-03-09

/* USER CODE END Header *//* Includes ------------------------------------------------------------------*/#include "main.h"/* Private includes ----------------------------------------------------------*//* USER CODE BEGIN Includes */#include <string....

pagurudeen · 2024-03-22

I'm using STM32H563ZIT6 controller and facing the same issue as above while trying to connect from STM32CubeProgrammer.Just Powered up the board and trying to connect in normal mode through programming pins (SWDIO, SWCLK), I have verified the connect...

pagurudeen · 2024-03-11

Sorry for the delay, I have increased the sampling time every steps up to 640.5 cycles but the still the ADC value is oscillating as earlier. I have checked the Vref+ and VDDA pin voltage on scope and the voltage varies from 3.28V to 3.3V and On grou...

pagurudeen · 2024-03-09

Thanks for the reply, I have calibrated the ADC as you mentioned and the results are better but still I'm getting the ADC value up to 96.if (HAL_ADCEx_Calibration_Start(&hadc1, ADC_SINGLE_ENDED) == HAL_OK){HAL_UART_Transmit(&huart7, (uint8_t*)"Succ...

User statistics

User Activity

ADC value Oscillates form 0 to 151 even when the ADC pin is grounded

Re: Cannot connect to access port 1

Re: ADC value Oscillates form 0 to 151 even when the ADC pin is grounded

Re: ADC value Oscillates form 0 to 151 even when the ADC pin is grounded