About Bob_Walton

Bob_Walton · 2024-04-21

I am using STM32Cube Version: 1.15.0 Build: 20695_20240315_1429 (UTC) and on an STM32F767ZGTx with FW_F7 V1.17.1I have a running and tested application for which I am now including FW Update from SDCard.I got two examples on which to base the new cod...

Bob_Walton · 2023-11-28

I have developing my project for some weeks now with no issues, then suddenly I cannot open the IOC file to modify the pin configuration. Worked on Monday, doesn't work two days later. no files have been copied or duplicated, just pushed to git.I hav...

Bob_Walton · 2024-04-25

After a bit of head scratching I finally got STM32Cube and STLink to share the same debug session and therefore was able to debug my application code after the jump.I went back to the original example code which showed I was jumping correctly to the ...

Bob_Walton · 2024-04-23

Sorry typo APPLICATION_ADDRESS = 0x08010000I have corrected and used <V> as requested.I will investigate further given the comments so far and post the outcomes.Thankyou everyone.

Bob_Walton · 2023-11-30

@Peter BENSCH Yes, I am using GuiHub as the repository for pushing my code changes. Do you suspect there is a link between the push and the IOC read problem?At the end of each day I push my repo, so the fact that the problem appears between two days ...

Bob_Walton · 2023-11-29

The file has not been renamed and there is only one IOC file in the project.I did manage to recover by doing the following.create a new project from the IOC filecopy the IOC and overwrite the old fileedit the IOC to set the project name and IOC file ...

User statistics

User Activity

IAP Jump to application not working

STM32CubeIDE - Open IOC file stopped working without warning

Re: IAP Jump to application not working

Re: IAP Jump to application not working

Re: STM32CubeIDE - Open IOC file stopped working without warning

Re: STM32CubeIDE - Open IOC file stopped working without warning