About marco239955_stm1

marco239955_stm1 · 2023-09-20

Hi,while doing a symbol for the Nucleo in KiCad I found that the Pin CN7.14 should be PA7 instead PB5.The sub-note (3) is correct.Best regardsMarco

marco239955_stm1 · 2014-09-18

Posted on September 18, 2014 at 21:34Hi, few days ago I downloaded the file ''STM32_FOC_SDK_4.0.0_Web_140625.exe'' from your homepage and wanted to try out the motion control on my custom board equiped with an STM32F407ZG device (either as single dr...

marco239955_stm1 · 2023-09-24

Hi Issamos,thank you for the hint.I also had a look in the schematics of board, where it is more clear to see than in the sentence"3. PA7 is used as D11 and connected to CN7 pin 14. If SB31 is ON, it is also connected to Ethernet PHY as RMII_CRS_DV. ...

marco239955_stm1 · 2021-12-16

Exactly this solves at least my Errors. In all other peripheral I use (SPI, UART) it is generated this way. First enable Peripheral clock, then GPIO clock. If first doing GPIO stuff first and then Enable Peripheral it looks in case of I2C like playi...

User statistics

User Activity

"UM2407 Rev 3 User manual", table 18, "CN7 ZIO Connector pinout" pin name of pin 14 wrong

FOC 4.0 and STM32F4xx

Re: "UM2407 Rev 3 User manual", table 18, "CN7 ZIO Connector pinout" pin name of

Re: STM32L4R5ZI gets stuck after initializing I2C