FAQs
lasersocks
Associate II
since ‎2018-07-19
‎2023-06-14

User statistics

  • 4 Posts
  • 0 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

What is the actual design of the accelerometer low pass filter?

2022-03-03
I am attempting to use the LPF2 chain on the LSM6 accelerometers. The cut-off frequency is described as something like ODR_XL/100. I assume that means if you are running at 12.5 Hz the cutoff frequency is then .125 Hz. I am assuming that this is the ...

Using both State Machines independantly

2014-10-09
Posted on October 09, 2014 at 20:52I am using the LIS3DSH. Does anyone have any experience using both state machines at once? Both of the State Machines can be used when run by themselves, but when both operate at the same time, after a few interru...

LIS3DSH differentiate between State Machine 1 and 2 on INT1 pin

2014-08-28
Posted on August 28, 2014 at 16:25I am using both state machines on the LIS3DSH to analyze two different types of movement. I only have room to use a single INT pin, so I am trying to direct both state machines to it running at the same time. When t...
Top