FAQs
TomChu
Associate
since ‎2023-10-24
‎2023-11-06

User statistics

  • 2 Posts
  • 0 Solutions
  • 1 Kudos given
  • 0 Kudos received

User Activity

Firmware error detected by Profiler n ST Motor Pilot V1.2.4

2023-11-06
Hi, I was trying to use Profiler in Motor Pilot to find motor settings for the evaluation board (ESPIN32F0602S1). However, I found out that the current version of Pilot (V1.2.4 from MC Workbench V6.2) didn’t support the evaluation board (ESPIN32F0602...

How to config Mechanical parameters for Motor parameters in MC Workbanch V6.2

2023-10-24
When I try to set all details into the Motor Control Workbench (with Hall Sensors) at Motor Parameters, there are fields for Inertia and Friction, that I am not sure how to configure.The motor spec is as below images.  What should I set for Inertia a...
Kudos given to
View all
Top