About dagan

dagan · 2023-10-21

Hi,I'm looking for the information about the number of sensor ADC samples per output data, in low power mode Vs. the high resolution mode.I found the following description in AN5069:"The difference distinguishing the two modes is in the number of sam...

dagan · 2024-02-21

When removing the configASSERT definition, "Break-All" while in STOP1 and then "Step Over" few times, I'm getting the hard faultthe LR is pointer to the first instruction of HAL_PWREx_EnterSTOP0Mode(STOPEntry):HAL_PWREx_EnterSTOP0Mode(STOPEntry);0x08...

dagan · 2024-02-21

Adding more details:When the configASSERT is define as a breakpoint#define configASSERT( x ) if ((x) == 0) {__asm volatile("BKPT #01"); taskDISABLE_INTERRUPTS(); for( ;; );}and I "Break All", the PC is inside the HAL_PWREx_EnterSTOP1Mode function, in...

dagan · 2024-02-21

Hi,Any update here?I'm having the same issue on WB55, running using visualGDB 5.6R9 on visual studio.I've also noticed that adding the following ASSERT definition causes this to happen every time I try to "Break All" (pause) with the debugger:#define...

dagan · 2023-10-23

Hi Federica,I need this information because we are trying to build a simulation model (python) for our project and replace the sensor with X-Y-Z injected samples.The samples was recorded from high resolution magnometer sensor, and we need to decimate...

User statistics

User Activity

LIS2MDL number of samples in low power mode Vs high resolution mode

Re: Why am I getting a hard fault when adding a breakpoint in the IDE while the device is in stop mo

Re: Why am I getting a hard fault when adding a breakpoint in the IDE while the device is in stop mo

Re: Why am I getting a hard fault when adding a breakpoint in the IDE while the device is in stop mo

Re: LIS2MDL number of samples in low power mode Vs high resolution mode