About Montagny

Montagny · 2023-10-19

Hi,I'm trying a simple program with a modulo operator on a STM32G031 MCU. Everything works fine during launch. But when using debug, it says "No source code available for _udivsi3() at 0x08000204".I know that the debugger is unable to find the source...

Montagny · 2023-10-23

Thanks all for your help. As @Bob S suggests, STM32CubeIDE > Run > Remove All Breakpoints did the trick. Can't believe it was so obvious but I really don't know how these BP set up at this address. Regards,

Montagny · 2023-10-19

Ok many thanks for your replies. But there is still a behavior that puzzles me.@Bob S I don't have any breakpoints anywhere, but the debugger stops by itself on this specific instruction (telling me that it can't find the source code). The problem is...

User statistics

User Activity

No source code available for _udivsi3 on STM32G0

Re: No source code available for _udivsi3 on STM32G0

Re: No source code available for _udivsi3 on STM32G0