About bvd

bvd · 2023-10-11

hello:as mentions on title,my target board is NUCLEO-C031C6. and I change the read protection level of flash from 0 to 1(0xAA to 0xBB) by STM32CubeProgrammer.after that, the target board can not be connect any more.(keil c/ cubeMX/ cubeProgrammer/ ST...

bvd · 2024-01-24

hello:i am sorry, this issue still exists, i can't do anything without connecting the mcu.

bvd · 2023-10-12

hello Simon:I have try (hot plug/ normal/ under reset/ power down) mode, it still not work,...the target can not be detected and show message as below:the only different is when I click [Connect] on power down mode, the error message appears 1 sec sl...

bvd · 2023-10-11

hello Simon:thanks so much for replying.about "However do you know if you configure other option byte like boot_lock ?"...maybe!I just selected [0xBB](level_1) and then click [APPLY]...on STM32CubeProgrammer.after reconnect power, the board can not b...

User statistics

User Activity

after change the RDP of FLASH from lv0 to lv1, the target could not be detected on NUCLEO-C031C6

Re: after change the RDP of FLASH from lv0 to lv1, the target could not be detected on NUCLEO-C031C6

Re: after change the RDP of FLASH from lv0 to lv1, the target could not be detected on NUCLEO-C031C6

Re: after change the RDP of FLASH from lv0 to lv1, the target could not be detected on NUCLEO-C031C6