About sdashmiz

sdashmiz · 2014-07-17

Posted on July 17, 2014 at 21:41Hi,I have programmed stm3220G-sk to read two ADC values from two different adcs ADC 1 & 2.When I connect DC power supply to check the readings, it can read values from 1 v to 3.3 v but cannot read values below 1 v, ke...

sdashmiz · 2014-07-07

Posted on July 07, 2014 at 22:19Hi,I am using STM3220G-SK to read adc values from an external source.I have tried different codes but all of them give me the same result. once the program is fired the adc valued is read and shown on the LCD but afte...

sdashmiz · 2014-07-17

Posted on July 17, 2014 at 19:28Actually the main problem is reading 0 , it does not give a stable zero reading but the the highest voltage is exactly 3.3 volts

sdashmiz · 2014-07-17

Posted on July 17, 2014 at 18:08The former problem solved now, I can read the ADC but there is voltage offset that increases with the voltage applied from PO, do you have any idea why this happens?Thanks

sdashmiz · 2014-07-10

Posted on July 10, 2014 at 23:00Thank youPC5 is channel 15 of ADC2 according to manual.I added a line Adcdata = ADC_GetConversionValue(ADC2); so at least the value is correct but there is no change of value, do you have any specific jumper in the ...

sdashmiz · 2014-07-09

Posted on July 10, 2014 at 01:15Thank you very much for your reply,I was trying to use two different ADCs at the same time, I have cleaned the code and I am using only one channel of ADC2 to read an external value. My neat code is below, however, th...

User statistics

User Activity

Problem Reading Low ADC Value

Problem in Reading continuous ADC value

Re: Problem in Reading continuous ADC value

Re: Problem in Reading continuous ADC value

Re: Problem in Reading continuous ADC value

Re: Problem in Reading continuous ADC value