About peepn61

peepn61 · 2023-06-28

I have a problem with STEVAL-PTOOL1V1 (for sensorless use added needed components)The project was built with:The board description from https://community.st.com/t5/motor-control-mcu/dear-st-i-need-to-find-the-download-quot-motorcontrol-workbench/m-p/...

peepn61 · 2023-07-19

Hi Fred,I am working with PTOOL1V1 (target to run) and SPIN3204. No more overcurrent. One of the windings of the motor was damaged, low BEMF. I replaced the motor.Now with the SPIN3204, the motor runs flawlessly. But If I use the same motor parameter...

peepn61 · 2023-07-19

Thanks for the suggestion. One of the windings of the motor was damaged, low BEMF.I replaced the motor. In the meantime, I picked up a STEVAL-SPIN3204 and the motor runs flawlessly with it. If I use the same motor parameters and speed settings with S...

peepn61 · 2023-07-06

Could you please comment in the same depth? Speed Sensing --> Sensorless start-up parametersIn my case Overcurrent or HardFault_Handler

peepn61 · 2023-07-06

Hi,I had the same problem when started. You can check for compiler optimization options under Project/Properties. Using Uart is important, it grants the Motor Pilot

User statistics

User Activity

STEVAL-PTOOL1V1 board is going to TSK_HardwareFaultTask()

Re: Trouble with STEVAL-STSPIN3201

Re: STEVAL-PTOOL1V1 board is going to TSK_HardwareFaultTask()

Re: Trouble with STEVAL-STSPIN3201

Trouble with STEVAL-STSPIN3201