About dbuso.11

dbuso.11 · 2022-11-15

Hi,I have a STEVAL-SPIN3204 board. I have opened the 6step_steval_spin3204 project on the ST motor control workbench, generated the code withe the following parameters using UPDATE button:STM32CubeMx: 6.5.0Target Toolchain: Keil MDK-ARM V5Firmware Pa...

dbuso.11 · 2022-11-21

Hello Cedric,Exactly the same issue with a baud rate set to 1843200 in main.c and in motor control.Just after connection established, I get in the terminal the message "ASPEP_BEACON Mismatch on crc_cpacility RXS_MAX TXS_Max TXA_Max" and connection is...

dbuso.11 · 2022-11-18

Hello Cedric,Thank you very much, the patch works.Nevertheless new problems arise: As soon as I want to send an instruction through ST motor PILOT, I get the message Port Open but no answer from board. I have to uncheck Polling in order toi have a st...

dbuso.11 · 2022-11-17

HelloI tried with the 5.Y.3 but with cubeMx version 6.4 code generation never start to generate code (stucked before anything is done). I downgrade to cubeMx version 6.3 and in this case code generation is OK. But once I opened the generated files un...

dbuso.11 · 2022-03-17

Hi,Same issue on the same board.I've tried to connect to the eval board usid STM32CUBEProgrammer only to see if I can, establish a connection and I get the message: "No STM32 target found"I use the last version of STM32CUBEProgrammer, the last ST-lin...

User statistics

User Activity

Connection Failed SPIN3204

Re: How to configure the board for experimenting in MotorPilot with STEVAL-SPIN3204? The PC recognises the evaluation board and I followed the steps in the MotorPilot manual. But I always get warning - Port Open and try to configure the board.

Re: How to configure the board for experimenting in MotorPilot with STEVAL-SPIN3204? The PC recognises the evaluation board and I followed the steps in the MotorPilot manual. But I always get warning - Port Open and try to configure the board.

Re: How to configure the board for experimenting in MotorPilot with STEVAL-SPIN3204? The PC recognises the evaluation board and I followed the steps in the MotorPilot manual. But I always get warning - Port Open and try to configure the board.

Re: Error while Loading code to board SPIN3202