About SDi B.2

SDi B.2 · 2022-06-07

Hello,I wanted to ask if it would be possible to have the sequence of commands sent and how they should be formatted, by the STM32CubeMonitorRF tool to the board, so possibly I can recreate those steps even with a custom program.Thank you very much

SDi B.2 · 2022-06-06

Hi,I am currently working on a bluetooth application, on an STM32WB55 microcontroller, to which I have integrated OTA update functionality.As Loader I used the one present in the provided code examples.The application and downloads work properly, my ...

SDi B.2 · 2022-03-01

Hi,I am currently working on a bluetooth application developing it on Nucleo STM32WB55 (FW version V1.13.1, BLE Stack Full).If the system is in a low power state, STOP2, can it be woken up via bluetooth?If so, is this awakening established by any kin...

SDi B.2 · 2022-02-28

Hi,I am currently working on a bluetooth application developing it on STM32WB55 Nucleo (FW version V1.13.1, BLE Stack Full)Since the device will have to be connected to a battery, I was researching the use of Low Power modes.Unfortunately, I'm not cl...

SDi B.2 · 2022-03-03

Hi @Amel NASRI ,I have already analyzed that example by integrating it into the Heart Rate one, creating my own procedure for reaching STOP2 mode even with bluetooth on, I just wanted to know if there was a precise procedure or not but at this point...

User statistics

User Activity

OTA Firmware update sequence

Management of OTA download of a corrupted binary in an STM32WB BLE application

Wakeup procedure via BLE for system in low power mode

Correct procedure to enter in STOP2 mode in stm32wb, with BLE stack active?

Re: Correct procedure to enter in STOP2 mode in stm32wb, with BLE stack active?