FAQs
gbarbour
Associate III
since ‎2018-07-19
‎2023-06-14

User statistics

  • 16 Posts
  • 1 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

What is the base address of the VL6180X registers?

2018-04-25
Posted on April 25, 2018 at 21:56Looking at the data sheet for the VL6180X (p49-50), the registers are listed with their 'offset' address.Does this mean I have to add a base address to the offset addresses? If so, where is that found in the document...

LIS3DH low output registers outputting random data

2018-03-30
Posted on March 30, 2018 at 18:51I have the LIS3DH accelerometer set for no FIFO, X,Y & Z output, Hi Res. I have BDU turned on.I am reading the high byte of each axis and getting the expected data which changes with accelerometer position. In all ca...

PCB Boards for STM32F429 176 pin or 208 pin versions?

2014-04-30
Posted on April 30, 2014 at 23:56 .ExternalClassC45DEEA78D324C0E97A656CD9497960D P {margin-bottom:0.08in;} .ExternalClassC45DEEA78D324C0E97A656CD9497960D A:link {;} Hello,I would like to design a product based on the STM32F429 chip. I first tho...

STM32F429I-Disco SDRAM disable question

2014-04-26
Posted on April 27, 2014 at 02:22 .ExternalClassFB32C94191F74142971920E4B5386622 P {margin-bottom:0.08in;} I have the STM32F429I Disco board and would like to use more GPIOs than the 27 free ones available in the current board configuration.I see...

Etch-A-Sketch for STM32F429i-Disco using 2 ADC channels and two extnl pots

2014-04-21
Posted on April 22, 2014 at 02:46The original post was too long to process during our migration. Please click on the attachment to read the original post.
Top