About JHule.1

JHule.1 · 2020-03-25

I am using a nucleo-f401re board.

JHule.1 · 2020-02-10

JHule.1 · 2020-03-26

Thank You, that worked, while watching the how to videos the guy says change the optimization level, but he was using Keil, that didn't do me any good when I was using STM32 Cube IDE, I looked for a user manual but ST didn't seem to have much.

JHule.1 · 2020-02-20

Thanks

JHule.1 · 2020-02-18

The only other manufacturer I have experience with is Microchip, and there IDE has a lot of bugs in it, that's why I was looking at ST but it looks like 8bit for them is an after thought.

JHule.1 · 2020-02-17

Thank You, that’s what I was thinking.

JHule.1 · 2020-02-17

Thanks.

User statistics

User Activity

how do i change code optimization

Hello, I am new to ST micro, and was wondering if any one can tell me what IDE I should be using to program the STM8 series, down loaded the cube, but there is no compiler there.

Re: how do i change code optimization

Re: Hello, I am new to ST micro, and was wondering if any one can tell me what IDE I should be using to program the STM8 series, down loaded the cube, but there is no compiler there.

Re: Hello, I am new to ST micro, and was wondering if any one can tell me what IDE I should be using to program the STM8 series, down loaded the cube, but there is no compiler there.

Re: Hello, I am new to ST micro, and was wondering if any one can tell me what IDE I should be using to program the STM8 series, down loaded the cube, but there is no compiler there.

Re: Hello, I am new to ST micro, and was wondering if any one can tell me what IDE I should be using to program the STM8 series, down loaded the cube, but there is no compiler there.