We have increased the log level in the UDE. > The core is not going into halt state its continuously on the running state. and we have searched regarding this on the datasheets provided and we have come up with some findings. >We have check...
we need to know that how to increase the log value in the "PLS UDE " we are currently using the SPC56P board and spc5studio along with that we are using UDE STK 5.2 for the flashing.
we have spc560P board with us in which we believe a resistor has been not responding in the line . because of that we are getting a response from the board as destructive reset.
Thanks for assisting us early. Can you guide us on how to increase the log level in PLS UDE. We looked for a solution but were unable to find one. Please kindly help us out.
