About GIabi.1

GIabi.1 · 2023-03-24

Good morning community,I am contacting you to ask for support regarding a EMC immunity problem I'm experiencing.My application uses an stm32g491cc MCU with an external 8 MHz ceramic resonator (HSE)What i observe is a reset of the microcontroller duri...

GIabi.1 · 2020-03-13

Good Morning,I am currently using a Nucleo -board stm32g474re, but I am unable to configure eclipse to connect to the Nucleo using the ST-Link v3.Is it possible to configure eclipse to debug using the ST-Link v3 of the Nucleo board?In the past with N...

GIabi.1 · 2020-01-10

Good morning,i' m working with stm32g4 and formy application i need use internal opamp in non- inverting configuration withexternal resistor how show the figure below (figure form AN5306). I don’t understand if is possible connect the output of opamp...

GIabi.1 · 2020-09-24

Yes is true, the ST-Link v3 is not supported by Segger tool. I by-passed the ST link and i used the MIPI10 connector of nuceo board to link the j-link debugger (JTAG/SWD) of the Segger.

GIabi.1 · 2020-09-22

Hi, thank you for the answer.No, in the end I used the j link.thanks for the suggestion

GIabi.1 · 2020-01-12

Hello Andrea,thank you for the answer.I'll try to apply this solution.Best regardsGianluca

User statistics

User Activity

Unwanted NMI interrupt of CSS peripheral of stm32G491CC

Is it possible to configure eclipse to debug using the ST-Link v3 of the STM32G474-Nucleo board?

config OPAMP in non-inverting configuration with the output of opamp connected to ADC: is it possible?

Re: Is it possible to configure eclipse to debug using the ST-Link v3 of the STM32G474-Nucleo board?

Re: Is it possible to configure eclipse to debug using the ST-Link v3 of the STM32G474-Nucleo board?

Re: config OPAMP in non-inverting configuration with the output of opamp connected to ADC: is it possible?