About SDowr.1

SDowr.1 · 2020-09-28

I have just recieved this circuit board and im trying to program it with an ST-LINK V2 however i keep getting the error "no stm32 target found" when trying to connect to it through SWD. Could someone help me?

SDowr.1 · 2020-09-28

The components were soldered by JLCPCB and the chip is the correct orientation. What would you suggest I do?

SDowr.1 · 2020-09-28

I’ve only been using pin one on the ST-LINK for power, is this likely to be my issue?

SDowr.1 · 2020-09-28

Would I apply 3.3v to the reset on power up to do this? And do I have to remove the pull up resistor and jump this pads?

User statistics

User Activity

I have just recieved this circuit board and im trying to program it with an ST-LINK V2 however i keep getting the error "no stm32 target found" when trying to connect to it through SWD. Could someone help me?

Re: I have just recieved this circuit board and im trying to program it with an ST-LINK V2 however i keep getting the error "no stm32 target found" when trying to connect to it through SWD. Could someone help me?

Re: I have just recieved this circuit board and im trying to program it with an ST-LINK V2 however i keep getting the error "no stm32 target found" when trying to connect to it through SWD. Could someone help me?

Re: I have just recieved this circuit board and im trying to program it with an ST-LINK V2 however i keep getting the error "no stm32 target found" when trying to connect to it through SWD. Could someone help me?