FAQs
YJain.1
Associate II
since ‎2019-12-17
‎2023-06-14

User statistics

  • 13 Posts
  • 0 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

I am using the STM32G0xx_LL_Driver on the Debian product based on DragonBoard820c. We have the Snapdragon 820 processor which I have used as master, and MCU from ST is the slave device. For SPI transaction I'm unable to toggle Chip Select pin.

2020-03-16
GPIO_InitStruct.Pin = SPI_NSS_Pin; GPIO_InitStruct.Mode = LL_GPIO_MODE_ALTERNATE; GPIO_InitStruct.Speed = LL_GPIO_SPEED_FREQ_LOW; GPIO_InitStruct.OutputType = LL_GPIO_OUTPUT_PUSHPULL; GPIO_InitStruct.Pull = LL_GPIO_PULL_UP; GPIO_InitStruct.Alternate ...

is there any linux kernel based SPI slave driver for STM32G071CBT6

2020-02-24
Hi Team,I want configure STM32G071CBT6 as SPI slave device. Is there any existing linux kernel driver for STM32G071CBT6?Thanks,Arun

How to enable GPGLL on Teseo-Liv3F module ?

2019-12-29
I am working with Teseo-Liv3F to test NMEA0183 strings over BLSP UART 12 on my board.wanted to know how reset and wakeup are used to monitor UART transfers ?How can we enable GPGLL, GPVTG on the module to obtain NMEA strings?To test the antenna used ...

How to enable GPGLL on Teseo-Liv3F module ?

2019-12-17
I am working with Teseo-Liv3F to test NMEA0183 strings over BLSP UART 12 on my board. wanted to know how reset and wakeup are used to monitor UART transfers ?How can we enable GPGLL, GPVTG on the module to obtain NMEA strings?To test the antenna used...
Top