Hello all,I have used TouchGFX for one project before (see https://www.eevblog.com/forum/projects/high-voltage-electronic-load-(500v-500ma)/msg4833872/#msg4833872)which was lots of trial and error, following some tutorials. I still find the architect...

Hello all,I'll be starting a project in TouchGFX designer from an existing template, say STM32F469I DISCO. How does the code generation by the TouchGFX designer and CubeMX interact? Say when I add an UI element and regenerate the code in designer, do...

Hi all,I have a STM32G474 and data in backup registers (eg. LL_RTC_BKP_DR0) are cleared after reset or power cycle (3.3 V battery is present!).Code is generated by CubeMX with LL drivers. I enabled RTC and disabled all tampers.In the main code, I can...

On the STDC connector, Pin 13/14 are virtual com port signals T_VCP_RX and _TX.Which one is input and output? They have cryptic comments like "Output for STLINK-V3SET" (for _RX) - Is RX an output and connects to the RX pin on the STM32? Or is it an i...