About JLamb.3

JLamb.3 · 2023-02-03

I put a logic analyzer on the I2C and INT1 line, and note that the INT1 continues to trigger but the I2C lines do not show data transfer anymore. Are there known issues? Is it a problem with the sensor or the host code? It may be dependent on the OD...

JLamb.3 · 2023-01-30

I have successfully built AlgoBuilder-based Firmware for my Target, including using some of the ISPU based examples from the x-cube-ispu GitHub:NUCLEO-L476RG + X-NUCLEO-IKS02A1 + ISM330ISWe are hoping to replace an old accelerometer and separate temp...

JLamb.3 · 2023-02-06

From the logic analyzer, I can see that the first transaction after the failure is an I2C read of the WHO_AM_I register which is the same thing that happens when the device is first plugged in. After 0.5s, it reconfigures the ISPU (1.6s) but never st...

JLamb.3 · 2023-01-31

Thanks, I did see that in the data sheet. Is the +/-15C an absolute accuracy specification that can be accounted for by a simple offset calibration? Or does the temperature vary significantly based on operating mode of the IMU components? Does the...

User statistics

User Activity

I have successfully built AlgoBuilder-based Firmware for my Target: NUCLEO-L476RG + X-NUCLEO-IKS02A1 + ISM330IS In Unicleo GUI, the data is streamed correctly for a few minutes but then stops abruptly. Why?

Getting temperature from ISM330IS in AlgoBuilder

Re: I have successfully built AlgoBuilder-based Firmware for my Target: NUCLEO-L476RG + X-NUCLEO-IKS02A1 + ISM330IS In Unicleo GUI, the data is streamed correctly for a few minutes but then stops abruptly. Why?

Re: Getting temperature from ISM330IS in AlgoBuilder