About MSZ1

MSZ1 · 2020-05-14

When "ST-LINK: Could not verify ST device!" error appears and what the mentioned verification process consists of? Can I influence verification process in STM32CubeIDE and how?I have STM32 MCU, which gives me "ST-LINK: Could not verify ST device!" in...

MSZ1 · 2022-08-16

Sorry for this necromancy, but this is simple problem I think. A.h must be understandable for both C and C++ compilers.In example below, Serial.h is C++ header with some classes and so on. A.h is included in main.c and both setup() and loop() functio...

MSZ1 · 2020-05-15

I was searching for chips looking similar to mine and I'm pretty sure it's not genuine. My problem was not about any different cputapid than this changed to 0x2ba01477, but generally debug process, when using ST-LINK (OpenOCD).It throws an error:"emb...

MSZ1 · 2020-05-15

Is there any way to read CPUTAPID from MCU with st-link v2? I know it's possible with J-Link, but st-link? Where is this value stored?

MSZ1 · 2020-05-15

Connecting under reset stalls the process for a while and fails as usual. Tried holding the reset for various periods, didn't help. I used connecting under reset to program other mcus many times, so I don't think I did something wrong.

MSZ1 · 2020-05-14

STM32F103C8T6, BluePill. Tried change CPUTAPID in "STM32CubeIDE\plugins\com.st.stm32cube.ide.mcu.debug.openocd_1.3.0.202002181050\resources\openocd\st_scripts\target\stm32f1x.cfg" from 0x1ba01477 to 0x2ba01477, but it doesn't work this time. Tried al...

User statistics

User Activity

ST-LINK: Could not verify ST device

Re: How to configure STM32CubeIDE to support C++ development?

Re: When "ST-LINK: Could not verify ST device!" error appears and what the mentioned verification process consists of? Can I influence verification process in STM32CubeIDE and how?

Re: When "ST-LINK: Could not verify ST device!" error appears and what the mentioned verification process consists of? Can I influence verification process in STM32CubeIDE and how?

Re: When "ST-LINK: Could not verify ST device!" error appears and what the mentioned verification process consists of? Can I influence verification process in STM32CubeIDE and how?

Re: When "ST-LINK: Could not verify ST device!" error appears and what the mentioned verification process consists of? Can I influence verification process in STM32CubeIDE and how?