About kRaje.1

kRaje.1 · 2025-03-06

When I tried to enable read protection level 1 through STM32Cube Programmer(using ST link and J link), I was able to do so successfully. However, after enabling read protection, none of the peripherals worked properly—specifically, the push button an...

kRaje.1 · 2024-11-06

Hi Team, I am facing an issue regarding the open bootloader. Recently, I downloaded the open bootloader source code for the STM32U0 boards, and I was successfully able to load hex files via the STM32Cube Programmer over UART. However, I encountered a...

kRaje.1 · 2024-08-29

How can I enable Serial Wire View (SWV) on the STM32U031R8 controller? I am receiving a "tracing is not supported" pop-up window. Additionally, when I try to enable it from the debug configuration, the option appears to be disabled. Could this be bec...

kRaje.1 · 2023-12-19

Hi Team i am facing some issue related to flashing code. previously i flashed the STM32Cube_FW_WL Lora wan example code into my stm32wl5cc controller PCB using J-link debugger. after successfully flashed the code i am trying to flash another code int...

kRaje.1 · 2023-09-29

Hi Team i have one doubt i am using stm32wle5cc controller and stm32wle5cc controller have 256Kb flash memory and each page is 2Kb. and stm32wle5cc controller flash memory support 10k cycles write operations after completes 10k write operations w...

kRaje.1 · 2023-10-15

it means is their any solution after 10k cycle write and read operation done on flash memory. i mean is their any HAL API's those can detect and moved the data to another page after 10k cycles completed.in STM32WL series Controllers.

kRaje.1 · 2023-10-15

Hi Team it means their is no solution from st electronics regarding Flash endurance. is their any software from st electronics like HAL API's Regarding Flash endurance.

kRaje.1 · 2023-05-24

hi team i have one doubt. now i want to use LORA RF Module AT commands again in my project so where can i get that AT command related firmware.

kRaje.1 · 2023-01-06

I have checked logs, J-Link connected but it showing below error.Could you please share how to connect the power lines to JTag. if you have any connection diagram, please share us.I have attached screen shots of below errors. Kindly check. Could not ...

kRaje.1 · 2023-01-06

No This board(LORA-E5 DEV BOARD(stm32wle5jc controller)) does not have onboard STLink.so i connected external j-Link debugger for code flash in stm32cubeide. but i am getting error like that. sir can help me how to resolve this problem.

User statistics

User Activity

Read Protection level 1

Facing an issue with open bootloader on STM32U0

How to enable serial wire view in STM32U031R8 controller

flashing error

Main Flash memory endurance

Re: Main Flash memory endurance

Re: Main Flash memory endurance

Re: HI TEAM i tried to unlock read and write protection of stm32wle5jc controller with external j-link programmer. but now pre-flashed AT command Firmware is deleted. now AT commands are not working. can you please help to resolve this issue.

Re: hi today i wrote a led blicky code in stm32cubemx and i am using external j link debugger to flash a code but i am getting a error like this.

Re: hi today i wrote a led blicky code in stm32cubemx and i am using external j link debugger to flash a code but i am getting a error like this.