About kRaje.1

kRaje.1 · 2023-09-29

Hi Team i have one doubt i am using stm32wle5cc controller and stm32wle5cc controller have 256Kb flash memory and each page is 2Kb. and stm32wle5cc controller flash memory support 10k cycles write operations after completes 10k write operations w...

kRaje.1 · 2023-09-24

Hi Team i have one question can i write data into stm32wl series boards OTP memory using j-link debugger softwares like segger j flash commander or segger j flash memory.i have another question is it possible to write data into stm32wl series boards ...

kRaje.1 · 2023-05-24

kRaje.1 · 2023-03-14

kRaje.1 · 2023-01-09

kRaje.1 · 2023-10-15

it means is their any solution after 10k cycle write and read operation done on flash memory. i mean is their any HAL API's those can detect and moved the data to another page after 10k cycles completed.in STM32WL series Controllers.

kRaje.1 · 2023-10-15

Hi Team it means their is no solution from st electronics regarding Flash endurance. is their any software from st electronics like HAL API's Regarding Flash endurance.

kRaje.1 · 2023-05-24

hi team i have one doubt. now i want to use LORA RF Module AT commands again in my project so where can i get that AT command related firmware.

kRaje.1 · 2023-01-06

I have checked logs, J-Link connected but it showing below error.Could you please share how to connect the power lines to JTag. if you have any connection diagram, please share us.I have attached screen shots of below errors. Kindly check. Could not ...

kRaje.1 · 2023-01-06

No This board(LORA-E5 DEV BOARD(stm32wle5jc controller)) does not have onboard STLink.so i connected external j-Link debugger for code flash in stm32cubeide. but i am getting error like that. sir can help me how to resolve this problem.

User statistics

User Activity

Main Flash memory endurance

OTP Memory j-link

i am using stm32wle5jc controller. so i am using adc in polling method and interrupt method in while loop. but i can't measure both samples at a time. i am getting only one adc samples after comment another(interrupt) method only.

may i know how to download stm32f429zi controller examples. can you please provide any link regarding examples.

hi team, i have one question can i use external j-link debugger for remove RDP and write protection and also flash the code into the controller(STM32WLE5JC) LORA-E5 board. and also please provide j-link debugger software to remove protection.

Re: Main Flash memory endurance

Re: Main Flash memory endurance

Re: HI TEAM i tried to unlock read and write protection of stm32wle5jc controller with external j-link programmer. but now pre-flashed AT command Firmware is deleted. now AT commands are not working. can you please help to resolve this issue.

Re: hi today i wrote a led blicky code in stm32cubemx and i am using external j link debugger to flash a code but i am getting a error like this.

Re: hi today i wrote a led blicky code in stm32cubemx and i am using external j link debugger to flash a code but i am getting a error like this.