About jovial_canopy

jovial_canopy · 2019-11-21

Hi,I would like to enable DMA for the FATFS+SDIO on my STM32F103RET6 board. However, I could not find the option in the Middleware -> FATFS -> Advanced Settings. Do you guys know what's happening?Environment:STM32CubeMX ver 5.4.0STM32CubeF1 Firmware ...

jovial_canopy · 2022-01-24

Great and clear post. Thank you!

jovial_canopy · 2019-11-22

I think it is possible to integrate it into the Arduino framwork. You can first use the CubeMX to generate the two folders, "USB_DEVICE" and "Middlewares/ST/STM32_USB_Device_Library", which provides all the necessary code for enabling the VCP (I have...

jovial_canopy · 2019-11-22

Hi Jan,Thanks for your answer. The one I use (STM32F103RET6) has 512 Kbytes Flash, which falls into the high-density category. I can configure the DMA for the SDIO interface, and it works well. It just has problem with the FATFS. I could not find any...

jovial_canopy · 2019-11-21

If you are not using CubeMX, probably there is no "middleware" things. Right now I use the micro USB port on blue pill to realize the virtual com port function. You can check this video for the details: https://www.youtube.com/watch?v=AYICE0gU-Sg I d...

jovial_canopy · 2019-11-21

How is your ST link connect to the Blue pill, via the SWD port?If you meant the USB CDC Virtual COMM Port, it work via the USB connector directly, instead of through the ST Link. Don't forget to add "USB_DEVICE" in the middleware.

User statistics

User Activity

Why there is no "Use dma template" option for STM32F103?

Re: How to generate a one second interrupt using an STM32 Timer

Re: STLink V2 VCP COM port doesn't show up in Windows

Re: Why there is no "Use dma template" option for STM32F103?

Re: STLink V2 VCP COM port doesn't show up in Windows

Re: STLink V2 VCP COM port doesn't show up in Windows