About oekk

oekk · 2019-11-19

Hi, I am trying to deploy a Keras model that fits in the board STMH743XI-E02. In order to do so, I've created the model, and loaded it into the project according to the current documentation.I've tried to use several USART ports to enable communicati...

oekk · 2019-11-25

Hi, I've tried that too, and nothing different happens. I believe that the two projects are generated very differently.

oekk · 2019-11-20

I tried to load your project and same results. Here is the project that does work with UART:https://drive.google.com/open?id=1aguW4Pml_DTBC99QL4m8_DQpEvLd_yb4I attached it here in case I am missing something. Also attached, board jumpers and back of ...

oekk · 2019-11-20

Thank you for your time Daniel.I am using the exact same versions, and steps as you do, and still the same error.Is it possible that there is a defect on my board? If so, how to spot it?

oekk · 2019-11-20

I do have that configuration.

oekk · 2019-11-20

Maybe this is helpful,After generating the code without validating the model, and debuging it, it stops in these lines, in stm32h7xx_haluart.c:> /* Wait until flag is set */> while ((__HAL_UART_GET_FLAG(huart, Flag) ? SET : RESET) == Status)> /* Ch...

User statistics

User Activity

STMH743XI-E02 fails to validate NN model on target. LOAD ERROR: STM32 - no connected board(s), invalid firmware or the board should be re-started.

Re: STMH743XI-E02 fails to validate NN model on target. LOAD ERROR: STM32 - no connected board(s), invalid firmware or the board should be re-started.

Re: STMH743XI-E02 fails to validate NN model on target. LOAD ERROR: STM32 - no connected board(s), invalid firmware or the board should be re-started.

Re: STMH743XI-E02 fails to validate NN model on target. LOAD ERROR: STM32 - no connected board(s), invalid firmware or the board should be re-started.

Re: STMH743XI-E02 fails to validate NN model on target. LOAD ERROR: STM32 - no connected board(s), invalid firmware or the board should be re-started.

Re: STMH743XI-E02 fails to validate NN model on target. LOAD ERROR: STM32 - no connected board(s), invalid firmware or the board should be re-started.