About CTam.1400

CTam.1400 · 2019-11-11

My X-NUCLEO-GNSS1A1 does not have any response after changing the baud rate. How can I recover it?I have write the following commands to change the baud rate:$PSTMSETPAR,3102,0x5*66$PSTMSAVEPAR*58$PSTMSRR*49After setting to it , if fail to have any...

CTam.1400 · 2019-11-20

It can be recovered now. Thanks.

CTam.1400 · 2019-11-12

I set baudrate to 115200, and put the reset pin to GND. It keep at "Sync in progress". Is there any other way to reset it?If I enable the NVM, it failed as below: Teseo-Suite version is 5.2.3.4

CTam.1400 · 2019-11-11

Thank you. I use this command changing the baud rate from 115200 to 9600. Then, I try to check baud rate 9600 and 115200, but there are no any output in TX.Writing other commands also does not have any response for baud rate 115200 or 9600. I also u...

User statistics

User Activity

My X-NUCLEO-GNSS1A1 do not have any response after changing the baud rate. How can I recovery it?

Re: My X-NUCLEO-GNSS1A1 do not have any response after changing the baud rate. How can I recovery it?

Re: My X-NUCLEO-GNSS1A1 do not have any response after changing the baud rate. How can I recovery it?

Re: My X-NUCLEO-GNSS1A1 do not have any response after changing the baud rate. How can I recovery it?