About MPoll.961

MPoll.961 · 2019-11-08

No red errors, here is a screen shot,Thanks, Mike

MPoll.961 · 2019-10-29

MPoll.961 · 2019-10-24

If anyone has a working support number would be a big help. My Question is on the STM32F411 the data sheets state many of the lines are FT 5 volt tolerant, other team members don't believe this and want to use level shifters, they believe as many l...

MPoll.961 · 2019-10-29

Hey Thanks Olivier, that helped,Mike

MPoll.961 · 2019-10-24

Hey Thanks to you all for the nice Feedback is very helpful!

MPoll.961 · 2019-10-24

Hey thanks much for the quick response, we want to use all 3 I2C lines, all 5v FT, and many I/O lines. In my option this should be ok, but there are concerns with so many being 5v that it will be to much of a load on the micro. We could just use a...

User statistics

User Activity

I am getting a few Exclamation mark by items now that I am finished configuring, all my pins are green. Most of items I am using have a check mark by them, my UART1 has a Exclamation mark and say "Partly disabled conflict with I2C3 I2C I2C"

What is best way to terminate unused I/O lines, there is a lot of options on this tie high/low, set as outputs, I worked on a very low power project and we set them all to Tri-State.

This is Horrible experance! It's taken me an hour just to get this far. I can't find anyone to call on this question. The number they have for support is out of service, and any atempt to find a number to call just sends back to the number.

Re: What is best way to terminate unused I/O lines, there is a lot of options on this tie high/low, set as outputs, I worked on a very low power project and we set them all to Tri-State.

Re: This is Horrible experance! It's taken me an hour just to get this far. I can't find anyone to call on this question. The number they have for support is out of service, and any atempt to find a number to call just sends back to the number.

Re: This is Horrible experance! It's taken me an hour just to get this far. I can't find anyone to call on this question. The number they have for support is out of service, and any atempt to find a number to call just sends back to the number.