About ALins.2

ALins.2 · 2021-12-14

Hi, I'm trying to use the STLink CLI to reprogram option bytes on an STM32L4 MCU. The command is accepted, but doesn't reprogram the designed option:'C:\Program Files\STMicroelectronics\STM32Cube\STM32CubeProgrammer\bin\STM32_Programmer_CLI.exe' -c p...

ALins.2 · 2021-12-17

The CLI says 'Debug in Low Power mode is not supported for this device.' I'm not sure if device means the STLink-V2 or the MCU.The firmware puts the MCU into STOP2 mode often. In STOP2 mode, the CLI can't connect:PS > & 'C:\Program Files\STMicroelect...

ALins.2 · 2021-12-15

This was unexpected: holding down the external reset button while the CLI command is executing let the CLI tool connect to the CPU. This doesn't always work. I added the dlpm option to the connect command. I have valid code loaded in bank #1 and bank...

ALins.2 · 2021-12-15

Suddenly worse behavior. Attempting to connect with the CLI tool can't find the target. GUI also can't find the target to connect after using the CLI to try to connect. & 'C:\Program Files\STMicroelectronics\STM32Cube\STM32CubeProgrammer\bin\STM32_Pr...

ALins.2 · 2021-08-16

I had red X's on a particular virtual folder after migrating a TrueSTUDIO 9.3.0 project into STM32CubeIDE v1.7.0. Closing the project and IDE didn't help. Only the folders had the red X -- no problems were listed and no source file had a red X. Also ...

User statistics

User Activity

STLink CLI utility can't program option bytes

Re: STLink CLI utility can't program option bytes

Re: STLink CLI utility can't program option bytes

Re: STLink CLI utility can't program option bytes

Re: STM32CubeIDE shows Project folder with red crosses while 0 errors and 0 warnings