About avieira

avieira · 2014-02-12

Posted on February 12, 2014 at 17:44HelloI am trying to use the LIS3DH in FIFO Mode with Filter enabled.In this mode, the X-Axis, and Y-Axis values get some normal values (they oscillate between -10 and +10) but the Z-Axis value seems to have a bypa...

avieira · 2014-02-24

Posted on February 24, 2014 at 10:49HiYes, the difference between CTRL_REG_1 as 0x67 or 0x77 is the ODR rate, 200Hz or 400Hz.Depending how the I2C is configured and implemented (assuming you are using I2C) it could be complicated to read the output ...

avieira · 2014-02-21

Posted on February 21, 2014 at 10:27HiJust to update.I get the confirmation from ST that there is a problem with LIS3DH when using FIFO + HP-Filter and Z-Axis.Also get the confirmation, that LIS2 does not suffer from this problem.

avieira · 2014-02-20

Posted on February 20, 2014 at 13:19HelloTry to put CTRL_REG1 with 0x67 in order to enable the X-Y-Z Axis.

avieira · 2014-02-20

Posted on February 20, 2014 at 12:21HiI have asked to my local ST distributor if the LIS2DH has any problem for this kind of application.I am waiting for his confirmation.Thanks

avieira · 2014-02-19

Posted on February 19, 2014 at 18:28Hellothanks for the feedback.There i go redesign the PCB, since the footprint is not the same between LIS2D and LIS3D.thanks

User statistics

User Activity

Question about LIS3DH FIFO

Re: Configuring LIS3DH

Re: Question about LIS3DH FIFO

Re: Configuring LIS3DH

Re: Question about LIS3DH FIFO

Re: Question about LIS3DH FIFO