About Skane

Skane · 2024-05-19

Hi,I'm trying to run STM32F429 using LL library to send data periodically.as a start, i'm sending 1 char every 1 sec, but i'm receive a wrong char (i send 'A', i receive something not clear), and when i call my custom systemClockConfig function, th...

Skane · 2022-12-04

Hi,i have started this project using X-Cube-IOTA1 package and i added all libraries i need to replicate the same project example which is IOTA-Client. i manage to compile my version and run in the the STM32 B-L4S5-IOTA1 using freeRTOS, but the proble...

Skane · 2024-05-26

Hi,since last time, after it worked randomly (Add HAL library without using it and removing system clock config), i had to move forward and work on something else, now i back again to this problem since it didn't make sense, i looked on the HW of the...

Skane · 2024-05-20

@Andrew Neil, my mistake, i mean oscilloscopeI know HAL is higher than LL, and that's why i can't understand what HAL provides to the project to make it work, i didn't even call any HAL header, i just enabled it in the project (which mean it's visibl...

Skane · 2024-05-20

@Andrew Neil I can't use MCO, both pin are already used for I2C (i'm using dev board stm32f429) i already tried to use my oscilator but i see nothing in a working project, so i can't check the frequency, but as i said before, when i enabled the HAL ...

Skane · 2024-05-20

Before i check the frequency, i enabled the HAL library, still not using any HAL function, i'm using the same code, and it's working. how is this possible?is there weak function or any function that was redefined? is this something mandatory to do wh...

Skane · 2024-05-20

@Andrew Neilfirst of all, thank you for your helpi have tried many time to compare and check my project against a working project, i also removed all my code in main.c and copied the entire code from a working project that uses LL library and still d...

User statistics

User Activity

Wrong Data in STM32F4 + UART using LL (low layer) library

Why my project stuck in HAL_Delay()?

Re: Wrong Data in STM32F4 + UART using LL (low layer) library

Re: Wrong Data in STM32F4 + UART using LL (low layer) library

Re: Wrong Data in STM32F4 + UART using LL (low layer) library

Re: Wrong Data in STM32F4 + UART using LL (low layer) library

Re: Wrong Data in STM32F4 + UART using LL (low layer) library