About TH.16.336

TH.16.336 · 2020-06-30

Hello All,We are using STM32F446RE MCU on our custom board. We have attached the schematic for reset pin and we are able to see RESET pin is getting high or low but MCU reset is not observed in IDE.We have added a breakpoint in Main() function. When ...

TH.16.336 · 2020-06-16

Hello All,I am using custom board using stm32f446ret7 controller. I am creating a sample project using CUBEMX for this stm32f446re controller and trying to flash using st-link/v2. But has got one warning as below. Can anyone help in understanding whe...

TH.16.336 · 2020-06-16

I am using custom board with stm32f446re7 controller. For flashing that, I am using ST-Link/V2 debugger.Custom board has SWD 6 pin connector. Did below connections from ST-LINK/V2 to custom SWD connector. But facing below issue even after changing re...

TH.16.336 · 2020-06-16

Hello All,We have an custom board using stm32f446re controller which has 6 PIN SWD JTAG connector.We are using NUCLEO-F446RE kit as debugger to flash the custom board as explained in "6.2.4 Using ST-LINK/V2-1 to program and debug an external STM32 ap...

TH.16.336 · 2020-06-16

Hello All,We have an custom board using stm32f446re controller which has 6 PIN SWD JTAG connector.We are using NUCLEO-F446RE kit as debugger to flash the custom board as explained in "6.2.4 Using ST-LINK/V2-1 to program and debug an external STM32 ap...

TH.16.336 · 2020-07-02

Hello TDK,Thanks for the suggestion.Yes that was the issue as BOOT0 was pulled high in our case.

TH.16.336 · 2020-06-16

Hello All,There was a wrong SWDIO & SWDCLk connection from NUCELO SWD connector to custom board.After resolving the hardware connectivity, now we are getting the flashing issue as below.Open On-Chip Debugger 0.10.0+dev-00021-g524e8c8 (2019-04-12-08:4...

TH.16.336 · 2020-02-05

Yes True.I can read/check byte by bytes on each interrupt. And I can just save those bytes to some array. But on what condition again, I need to reset the index of array? so that I can save the next set of data/bytes starting from 0th index? Because ...

TH.16.336 · 2020-01-30

Thanks for the answer. It helped

TH.16.336 · 2020-01-30

Hello rrom,Thanks for the reply with all the information.Actually I want to count the step pulse from external source where I should increment the count every time I get the pulse interrupt. But the interrupt should be generated for very 10th pulse.T...

User statistics

User Activity

STMF446RE MCU reset issue in custom board

STm32f446REt7 controller examples code issue from cubemx

STM32F446RE - Flashing with SWD in reset held

STM32F446RET7 custom board flashing issue with SWD connector

CUSTOM STM32F446RE CONTROLLER SWD FLASHING ISSUE

Re: STMF446RE MCU reset issue in custom board

Re: CUSTOM STM32F446RE CONTROLLER SWD FLASHING ISSUE

Re: How to find number of chars/bytes to read over UART channel?

Re: How to use code compiled date & time in my code on STM32F446RE Nucleo board?

Re: NUCLEO- STM32F446RE : Counter example which works on step pulse from external source/pin