About RPinh

RPinh · 2019-11-12

Hi,I'm using the LSM6DSL AWT to get interrupts in Y-axis when the angle goes above or below the thresholds. The problem is when happens one change of directions the LSM6DSL gives a false positive interrupt. The sensor detects the horizontal movement ...

RPinh · 2019-08-27

Hi,I'm trying to configure the AWT function in the LSM6DSL. All works fine minus the latency. I change the latency to 0x01(40ms) but the interrupts keep with a delay of 600ms(default) between each one. Any idea what I'm doing wrong?Accelerometer band...

RPinh · 2019-08-29

Hi,Found the problem. The problem was that the pin of the INT2 in the MCU have debounce timeout.Best regards.

RPinh · 2019-08-28

What registers do I have to change to decrease the reaction time of the INT2? With this configuration, I have a reaction time of approximately 600ms(When I receive an interrupt in the MCU I read the FUNC_SRC2 to clean the interrupt). I need a reactio...

User statistics

User Activity

LSM6DSL Absolute Wrist Tilt(AWT) false positives

LSM6DSL AWT latency problem

Re: LSM6DSL AWT latency problem

Re: LSM6DSL AWT latency problem