About NMALH

NMALH · 2022-01-12

MCU is STM32F207VIT6 (client)server is windows application.LWIP library is used.Is there any ping command?

NMALH · 2021-07-14

NMALH · 2021-07-14

NMALH · 2021-02-23

NMALH · 2020-09-12

This is the register values set by me for 400g and data output rate is 50z

NMALH · 2022-01-12

already set to 1. Will you please elaborate more.

NMALH · 2021-07-15

We are connecting multiple clients with a single server. When the client sends a close connection command we are able to detect it on the server side, whereas when the client gets disconnected by any other means i.e. when the client is powered off or...

NMALH · 2020-09-17

Dear Eleon,Thankyou for the reply. Yes, my problem got solved. Before I was multiplying my readings with wrong value of sensitivity.

User statistics

User Activity

Lwip TCP Client disconnect detection. I am unable to detect if my client is disconnected from server. if my server sends the close command then i am able to detect but problem arises when the server stops abruptly or power goes down.

server-side knowledge of disconnection of the client without getting close command from the client .

Creating two task with one as realtime and second as idle priority, but as both task execute for say n minutes, program counter does not come into the task again, even you have a infinite for loop in both task.

VSC8512 12 port PHY IC interface with stm32 MCU

I am facing problems while interfacing the said accelerometer (H3LIS331DL) with ST microcontroller (STM32L432). By following the said application circuit from the datasheet, I am getting unstable readings.

Re: Lwip TCP Client disconnect detection. I am unable to detect if my client is disconnected from server. if my server sends the close command then i am able to detect but problem arises when the server stops abruptly or power goes down.

Re: server-side knowledge of disconnection of the client without getting close command from the client .

Re: I am facing problems while interfacing the said accelerometer (H3LIS331DL) with ST microcontroller (STM32L432). By following the said application circuit from the datasheet, I am getting unstable readings.