About Dthum.1

Dthum.1 · 2024-06-24

Hi Team,MCU: STM32G0B1Requirement: Flash memory protection is needed for the MCU code.I am using stm32g0b1 MCU for my project, where I have completed my development activities.MCU Flash contains two things. 1) MCU code 2) other important data related...

Dthum.1 · 2024-04-02

Hi all,I wanted to enable the write protection option byte using I2C bootloader ( Bootloader given by stm32). This can be done using the stm32 debugger also. but in my case requirement is using I2C bootloader only. MCU : STM32G0B1CET6communication pr...

Dthum.1 · 2023-08-16

Hello forum,we are facing a very strange issue with the STLINK-V3MINIE debugger.Controller: STM32G0B1CE seriesSTMprogrammer version: 2.14.0Debugger: STLINK-V3MINIEwe are trying to connect the device(controller) with the stm32programmer application u...

Dthum.1 · 2023-07-30

Hello forum,I am facing an issue related to i2c communication. Controller: STM32G0 seriesI2C mode: slave modeI have configured the controller as I2C slave mode with a single master.When I am configuring the i2c frequency 100khz, both (master and sla...

Dthum.1 · 2023-05-04

Dthum.1 · 2024-07-07

Hi @STeaThank you for your quick response and suggestions. I will check with my end application.Regards.

Dthum.1 · 2024-04-08

Hi @BPrac.1 Have you found any solution/workaround for this issue? I am facing a similar problem with STM32G0B1.

Dthum.1 · 2024-04-07

Hi Team,Does anyone have any idea about my issue with write protection using the system bootloader in stm32G0?I want to apply write protection using the system bootloader, which is not happening.your valuable input will be much appreciated.Thanks.

Dthum.1 · 2024-04-03

Hi @Tesla DeLoreanThanks for your quick response,>> Then consider other approaches... My code running on MCU can do this updation. But that will not fulfill the actual requirement.>> ..see if you can apply that knowledge vs the I2C method.I have gone...

Dthum.1 · 2023-12-06

Hi Goutham Update: Thanks for your valuable input, I have validated your fix on my setup by testing it 120 times, where I was facing the issue. it has worked each time and no issue I have found with this fix.thanks, a lot.here, what I have done is si...

User statistics

User Activity

Flash memory protection in STM32G0B1

How to enable write protection using I2C bootloder protocol

stm32programmer is not connecting with device(STM32G0)

I2C ARLO(HAL_I2C_ERROR_ARLO) error issue in STM32G0

Does the reset pin of the MCU needs to be configured from the software side in the .ioc file in stm32cubeide ?

Re: Flash memory protection in STM32G0B1

Re: Problem with option bytes set from program level- G0B1

Re: How to enable write protection using I2C bootloder protocol

Re: How to enable write protection using I2C bootloder protocol

Re: CFGBSY bit of FLASH SR register is SR is set it is not reset again in stm32g0b1cet6 controller #