User Activity

I have 3 Nucleo-WL55JC and 2 B-WL5M-SUBG1 systems all running same code and located within a 1 foot of each other.  Additionally I have custom sensors based on the STM32WL5MOC located 4 to 8 feet away.  The Nucleo-WL55JC modules report rssi values be...
The STM32WL5MOC datasheet (DS14084 - Rev 4 Feb 2024) contains the following comment on page 6."To keep an output power > 13 dBm, the TOS presented to the module should be ≤2."Will someone please tell me what TOS stands for. Best regards, Roy Cooley  ...
Using the NUCLEO-WBA52CG I have been trying to get debug logs to be set over SWO(PB3). Using a logic analyzer I can see the logging getting to CN4:10(PB3/SWO). The signal does not make it to the embedded STLINK-V3MODS pin 6. There are notes in the de...
I was able to program two Nucleo-WBA52CG using STM32CubeIDE and the on board ST-Link. I programmed them with the BLE_HeartRateThreadX example application. When I power them I can see the BLE_HeartRateThreadX BLE traffic on my phone. However, I can no...
Kudos from