About Muthanna

Muthanna · 2024-01-29

I tried searching for documentation to help me Calculate Current from set reference current in dpp unit.Can anyone kindly give simplified explanation on how to convert current from dpp to Ampere (DC) ?For the purpose of calculation..Or share a good d...

Muthanna · 2024-01-10

Hi, I'm using MCSDK 5.Y.2 and STSPIN32G4 on a custom board. (this is a software thing !)I couldn't find a way to get two (more than one) converted ADC Values using a single request using the RCM.So I carried on converting each channel sequentially.I ...

Muthanna · 2021-08-05

Hi, I had been using the older version of MCW w/ Monitor to use an STEVAL-ESC001V1.I got a new 30Pole BLDC to test out. Since the board does not support Hall Sensors I had hacked some test points and pads to pull out leads, re-configure the "Digital...

Muthanna · 2024-04-30

I'm facing the same problem with Motor Pilot (6.2.1) on my Windows 10 Pro 22H2. I've tried installing Visual C++ packages, it didn't help.When I open the application or launch it via the Workbench. The Application opens briefly in the background but ...

Muthanna · 2024-01-29

I faced similar issues very early on and it was due to noise in the hall sensor signal lines. Probe the MCU Pin nodes, especially during runtime if you see fluctuation in the signal crossing 1/2Vcc it could be triggering "HALL" Timer Interrupts. Use ...

Muthanna · 2024-01-28

void User_ADC_Init(void) { RegConv_t FES_ADC = {hadc2.Instance,MC_ADC_CHANNEL_7,ADC_SAMPLETIME_2CYCLES_5}; FEShandle = RCM_RegisterRegConv(&FES_ADC); /*RegConv_t TRTL_ADC = {hadc2.Instance,MC_ADC_CHANNEL_8,ADC_SAMPLETIME_2CYCLES_5}; TRTLhandle = ...

Muthanna · 2024-01-11

Thank you Cedric, The Board Manager was a bit confusing at first, figured it out. Going to make the transition from 5.Y.2 to 6.2.1 Fingers Crossed,Muthanna

Muthanna · 2024-01-10

Can't move to 6.2 yet because I cant adjust the current sensing feedback gain as per my custom board.Still with 5.Y.2 <3 , Can't download the same for my new pc (option is removed I guess).

User statistics

User Activity

Calculating DC Current drawn.

Regular Conversion Manager Crashing

Getting past Under voltage fault to start motor with EVSPIN32F02Q1S1. May be a bug.

Re: Motor Pilot application is not starting

Re: Wrong period values during motor startup.

Re: Regular Conversion Manager Crashing

Re: MCSDK 6.2.0 is out!

Re: MCSDK 6.2.0 is out!