About PWaiba

PWaiba · 2022-06-29

I am trying to know the status of MCP3424, either it is connected or not to the master STM32 with defined address 0x68. The ADC module gets connected with the Arduino in same address but using STM32, I am not able to get connected with the following ...

PWaiba · 2021-07-25

--The first error encounters while trying to connect the board (STM32H7A3ZI-Q) with STM32Cube Programmer at normal mode.--The second error encounters while trying to upload a code through STM32Cube IDE. However, when I try to connect the boa...

PWaiba · 2021-07-29

I followed the link and found that the issue was with my power configuration. By following the steps there, my issue is solved. Thank you @Community member .

PWaiba · 2021-07-29

Although the upgrade is successful, the error still encounters while uploading the code as cited in the picture.

User statistics

User Activity

DFRO316 MCP3424 and STM32

How to solve the problem with: 1. " Error: No STM32 target found!". 2. "Error in final launch sequence: Failed to start GDB server Failed to start GDB server Error in initializing ST-LINK device. Reason: (4) No device found on target."

Re: How to solve the problem with: 1. " Error: No STM32 target found!". 2. "Error in final launch sequence: Failed to start GDB server Failed to start GDB server Error in initializing ST-LINK device. Reason: (4) No device found on target."

Re: How to solve the problem with: 1. " Error: No STM32 target found!". 2. "Error in final launch sequence: Failed to start GDB server Failed to start GDB server Error in initializing ST-LINK device. Reason: (4) No device found on target."