I read document AN5209. This said " VDD must be lower than 0.2 V for at least 10 ms during power-off sequence for correct POR. (3.1 Figure 2)"If POR did not finish correctly, is there the possibility to be read the un-correct data?

In the case of power on, sometimes, the controller failed commnunication with LPS22HH.The controller side accesses LPS22HH in the following order of processing;1 power on2 wait INT_SOURCE (@24h) BOOT_ON = 03 Set the BOOT bit of the CTRL_REG2(@11h) re...

Hi, All!I'm using LIS3DHTR with range:2G, sensitivity:1mg/digit, HR:1.Now I get the raw value like these:X=-4800 Y=432 Z=15136These value are from the sensor which quietly placed on the table(sensor faced -Z on the table).If I get the "g" value ...fl...