Posted on November 07, 2013 at 00:26Does anyone know if you can set Mark or Space parity on the STM32 USARTS?I only found that you can set Even or Odd parity so far. I need to configure an STM32 for hardware that uses Mark and Space parity bits so a...

Posted on October 25, 2013 at 05:54 I'm trying to setup some communications between an STM32L152 series MCU with an ATMEGA The Atmega uses 5V logic high. I read the Datasheet and found that the UART1 RX pin is 5V tolerant on the STM32 so I shoul...

Posted on October 16, 2013 at 18:44I have been trying to us MicroXplorer to generate startup code for the STM32L152RC, but the only thing I seem to be able to configure is the System: GPIO configuration. I can't seem to access any of the other confi...