About YVeda.1

YVeda.1 · 2021-07-07

I'm working on the NUCLEO-H745ZI-Q development board and recently configured the clock to its max 480 MHz through STM32CubeMx and tried debugging the code generated by CubeMx on STM32CubeIDE. While suddenly the micro failed to respond after the `Syst...

YVeda.1 · 2021-07-07

Awesome, firmware upgrading the ST_LINK to V3J7M3 worked, now I'm able to connect and erase the flash. Thank you very much.

YVeda.1 · 2021-07-07

Thanks for the quick reply, I've tried the suggestion but getting a different error now. I'm using the latest CubeProgrammer 2.7.0.

YVeda.1 · 2021-07-07

Oops you are right the code I shared is wrong, I've updated the correct code generated by CubeMxI followed some ST examples and set the max to 480 Mhz, now I don't really want to go to max frequency.How do I revert the board back to a working state?

YVeda.1 · 2021-07-01

Can I get the patch or is it already deployed in the current release v2.7.0?I am facing a similar problem with the NUCLEO-H745QI board where the STM32CubeProgrammer is not detecting the target, getting `No STM32 target is found` error. This happened ...

User statistics

User Activity

No STM32 target found error after configuring the clock to max 480 MHz through STM32CubeMx

Re: No STM32 target found error after configuring the clock to max 480 MHz through STM32CubeMx

Re: No STM32 target found error after configuring the clock to max 480 MHz through STM32CubeMx

Re: No STM32 target found error after configuring the clock to max 480 MHz through STM32CubeMx

Re: How do I regain ST-Link connectivity with Nucleo-H745ZI-Q with BOOT_CM7 = 0 and BOOT_CM4 = 1