About Mh.1

Mh.1 · 2022-05-23

Mh.1 · 2022-05-10

Motor Pilot 6.0.0 will not connect to my target hardware. I am using:NUCLEO-G431RBSTEVAL-IPM30B (w/ NUCLEO adapter)generic BLDCWhen I click connect, I see the following message:Port Open and try to configure the board.Please advise!M

Mh.1 · 2021-07-29

Hardware: STEVAL-HKI001V2Workbench: 5.4.6Ex project name: STEVAL-HKI001v2 project with STGAP1ASIDE: uV5CubeMX: 6.2.1*note* this behavior seen with completely new/stock/vanilla/unedited Workbench, Cube, and uV projectsexpected behavior: click "monitor...

Mh.1 · 2022-05-20

I am interested to hear any further update in this area!I am trying to drive a BLDC/PMSM at 24V (5A max total system consumption) with my NUCLEO-G431RB and I have just acquired EVALSTDRIVE601 for testing purposes. I hope the ability for high freq PWM...

Mh.1 · 2021-08-03

Hi Laurent! Thank you for your prompt support. Please refer to the following images.image 01 - Breakpoint at line 114 of main.c where MX_NVIC_Init() is called. I reset the board and example code reaches this point as expected (see yellow cursor) imag...

Mh.1 · 2021-08-03

[redacted]I copy/pasted the body of this message into a reply to Laurent's message

Mh.1 · 2021-06-03

I am also curious about this topic. I am struggling to spin my (custom wound) motor using Workbench tool with HKI001V2 and I wonder if I should start with a known supported configuration (different motor?) to prove my dev toolchain is sound.

Mh.1 · 2021-06-03

I am also very interested in this topic. I have STEVAL-HKI001V2 hardware and I am struggling to get any results. I profiled my motor using a different EVM (steval-ipm30b) and I achieved results with that controller/inverter/motor combination, but now...

User statistics

User Activity

Network gain calculation for EVALSTDRIVE601 in ST MC Workbench (5.4.6) EVALSTDRIVE601 data brief shows R62 0ohm at current sense network. This short-circuit is missing in Workbench (5.4.6) network gain calculator. Can you advise that I de-solder R62?

How to troubleshoot comms between Motor Pilot and target?

STEVAL-HKI001v2 example project in ST MC Workbench, why can't I connect?

Re: I'm trying to run a 3-phase AC induction motor with a rating of 1HP or1/2 HP & for that, I want to use NUCLEO-F401RE, X-NUCLEO-IHM09M1, EVALSTDRIVE601.

Re: STEVAL-HKI001v2 example project in ST MC Workbench, why can't I connect?

Re: STEVAL-HKI001v2 example project in ST MC Workbench, why can't I connect?

Re: STEVAL-HKI001V2 PMSM Test Motor

Re: STEVAL-HKI001V2 Motor Profiler Support